Smoked Front Reflector Overlays for BMW F01 7 Series, F06/F12/F13 M6

Installation Notes

• Installation Difficulty: SIMPLE (No Tools, Anyone Can Install)
• To properly install this product, you must clean the application area with soap and water for the best possible adhesion.
• This product must be installed at room temperature. If your BMW is too warm or cold, the material runs the risk of not adhering properly.
• First, compare the overlay you've received with your reflector and make sure they are the same size.
• Thoroughly clean the reflector surface with an alcohol wipe and ensure that it is dry using a paper towel.
• Remove the adhesive at the back of the overlay and stick the overlay on the top of the reflector. Once the overlay is on
  the reflector, apply some heat with a blow dryer to help activate the adhesive.
• While applying, you may notice that the reflector overlay is slightly shorter in length than your original. To remedy this, gently stretch the material while applying it until you achieve the desired length. If you overstretch it, you can cut off the overlapping material with an Exacto knife.
• The film can easily be shaped and stretched, and therefore you may need to stretch the film slightly to fit edges and contours or cut off excess with a box cutter.

Notes / Warnings

• Please check your local laws to ensure legality when using this product on public roads and highways.
• In areas where this
  product is not legal for road use it is sold strictly for off-road, track or show use only.