Carbon Fiber Vinyl Door Sills for BMW F30/F31 3 Series

$24.50

  • Brand: DecalWerks
  • Availability: Out Of Stock
  • SKU: DSO3021YY
  • Barcode: DSO3021YY

Product Introduction Give your BMW door sills a carbon fiber finish with this easy to install overlay kit! Features and Benefits Of This Product Enjoy the look with Carbon Fiber with these Carbon Vinyl Door Sills. Simply overlay on top of your original sills for an immediately sportier look every time you drive. Each kit comes with 2 or 4...

Tags: BMW-F3X-3-Series-2012 , BMW-F3X-3-Series-2013 , BMW-F3X-3-Series-2014 , BMW-F3X-3-Series-2015 , BMW-F3X-3-Series-2016 , BMW-F3X-3-Series-2017 , BMW-F3X-3-Series-2018 , BMW-F3X-3-Series-2019 , Exterior Decals

Product Introduction

  • Give your BMW door sills a carbon fiber finish with this easy to install overlay kit!

Features and Benefits Of This Product

  • Enjoy the look with Carbon Fiber with these Carbon Vinyl Door Sills.
  • Simply overlay on top of your original sills for an immediately sportier look every time you drive.
  • Each kit comes with 2 or 4 pieces based on your BMW.

Installation Notes

  • Installation Difficulty: SIMPLE (No Tools, Anyone Can Install)
  • Ensure to remove any shine products that may have previously been applied to the door sills, along with any oil and dirt, with rubbing alcohol.
  • Failure to properly prepare the area will result in poor adhesion.
  • We recommend the use of soapy water for easy and accurate placement.
  • Put soapy water on the application surface AND on the back of the piece itself.
  • Once you are satisfied with the placement, gently press out the water with a cloth.
  • As the material's adhesive is heat activated, we recommend using a hairdryer or heat gun to evaporate the excess water and enhance adhesion.
  • If you find a portion is not sticking correctly, this indicates that there is still air or water under that piece.
  • Simply push any bubbles to the edges, and you're done.

Notes / Warnings

  • Use caution when peeling off or realigning to avoid stretching the material, or it will not fit correctly.
  • This is especially important with narrow or long pieces.
  • If the piece stretches it will most likely happen along a long thin area leaving you with excess material somewhere in the middle of the pattern.
  • If this occurs make a cut in the material with scissors, and fold over the two edges you just created by cutting the one piece.
  • Cut away any overlap and press down firmly.

Recently Viewed Products

$24.50